Fusion^THP is produced in our 100,000 square foot, state-of-the-art manufacturing facility strategically located in Fort Wayne, Indiana. Our revolutionary manufacturing process utilizes proprietary equipment for maximum output. We have implemented principles of Lean Six Sigma to increase manufacturing efficiency and reduce variation.

The most technologically advanced equipment and highest quality raw materials create the Fusion Panel’s high performance. Dedicated to quality and innovation, our distinguished management and technical team consists of chemical and process engineers, lab and quality technicians, and technical specialists with over 75 years of combined fiberglass manufacturing experience.

Storage Requirements

Keep contents dry. Store panels indoors in a well ventilated and dry location. Exposure to moisture will cause discoloration and lead to poor adhesive bonding.

Fabrication

Safety: Always wear protective eye goggles; cover nose and mouth with an air filter mask; cover exposed skin when cutting FusionTHP Panels.

Drilling: Use a high speed drill bit when drilling or hole saw.

Cutting: Use carbide-tipped saw blades.

Painting preparation: Sanding or roughening of the panel surface is not required to achieve acceptable paint adhesion, but is recommended. Panels must be clean, dry, and free of all oils, dust, and contaminants before paint application. Amerimax recommends that the FRP surface is either primer washed or solvent wiped to remove oils, dust, and contaminants.